Why do automatic polishing machines fail? How to avoid it?

In the process of using the automatic polishing machine, we may be affected by some factors, which may cause the equipment to malfunction, thus affecting its normal operation. Then you know why the polisher fails? What is the main reason? How to avoid it?

Let’s take a closer look:
In order to avoid the failure of our automatic polishing machine, we must pay attention to the bad behavior of the automatic polishing machine during the use of the automatic polishing machine. At the same time, in order to ensure that the service life of the automatic polishing machine and the use efficiency will not be damaged, be sure to pay attention to the following points when using the polishing machine daily. First of all, when using an automatic polishing machine, we must pay attention to whether the polishing machine is operated in a standardized manner. It is not possible to automatically operate the blind polishing machine, which is easy to cause damage to the polishing machine; when to use the polishing machine, we must avoid the occurrence of excessive polishing.
Load work, because this will directly affect the service life and the efficiency of the work polishing machine; in addition, when using the polishing machine, if the polishing machine fails, it should be stopped in time for inspection, and the polishing machine should not be used continuously. Polishing is carried out in two stages, the first is rough polishing, the purpose is to remove the polishing damage layer, this stage should have a larger polishing rate; the second is fine polishing, the purpose is to remove the surface damage caused by roughness Damage is minimized.
When the polishing machine is polishing, the grinding surface of the sample should be relatively parallel to the polishing disc and lightly pressed on the polishing disc to prevent the sample from flying out due to too much pressure and forming new wear marks. At the same time, the sample should rotate around the radius and move the turntable back and forth to prevent local wear of the polish too quickly. If the humidity is too high, the scratch effect of polishing will be reduced and the surface sample will be embossed and “smeared”; black spots. Ensuring a certain level of humidity is also key to polishing.